Viking Dishwasher E:03 Error Code
A Viking dishwasher that logs E:03 is asking for confirmation against the use & care guide. Simply Iconic can diagnose independently if the code returns.
Content status: Reviewed — wording follows cited Viking service literature; confirm decode on your exact model.
E-series code listed in Viking dishwasher ManualsLib fault index.
E:03 on Viking dishwasher controls: photograph it, try one reset, book Simply Iconic if it persists.
Model compatibility: Viking reuses codes across series and model years, so E:03 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Circulation fault — wash motor or diverter did not respond. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. Recurring faults after reset need an independent Viking technician via Simply Iconic.
Symptoms you may notice
- E:03 on display
- Cycle may stop or abort
- Related function disabled
Possible causes
- Component or sensor fault per manual
- Wiring or connector issue
- Control detected abnormal condition
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Reset the unit by pressing and holding the START button for four seconds, then try the cycle again.
- Record model and serial numbers
- Do not open control or motor covers
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
For recurring E:03, independent service is safer than guessing parts. Simply Iconic will diagnose on site and estimate before any repair.
Likely related component
Wash motor / circulation
Frequently asked questions
Circulation fault — wash motor or diverter did not respond. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. Recurring faults after reset need an independent Viking technician via Simply Iconic.
Safe homeowner resets may clear E:03 temporarily; sealed, gas, and live-board work stay with a technician.
If your manual lists a different description for this code, trust the manual over any general summary.
Sources & references
Model, symptom, ZIP — we’ll confirm a visit
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Use the secure scheduler below to request your appointment.