Viking Dishwasher E:10 Error Code
A Viking dishwasher that logs E:10 is asking for confirmation against the use & care guide. Simply Iconic can diagnose independently if the code returns.
Content status: Reviewed — wording follows cited Viking service literature; confirm decode on your exact model.
E-series code listed in Viking dishwasher ManualsLib fault index.
E:10 on Viking dishwasher controls: photograph it, try one reset, book Simply Iconic if it persists.
Model compatibility: Viking reuses codes across series and model years, so E:10 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Touch panel / UI fault — display or keypad communication error. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. If the problem persists after reset, book Simply Iconic for independent Viking dishwasher diagnosis.
Symptoms you may notice
- E:10 on display
- Cycle may stop or abort
- Related function disabled
Possible causes
- Component or sensor fault per manual
- Wiring or connector issue
- Control detected abnormal condition
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Reset the unit by pressing and holding the START button for four seconds, then try the cycle again.
- Record model and serial numbers
- Do not open control or motor covers
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
For recurring E:10, independent service is safer than guessing parts. Simply Iconic will diagnose on site and estimate before any repair.
Likely related component
User interface
Frequently asked questions
Touch panel / UI fault — display or keypad communication error. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. If the problem persists after reset, book Simply Iconic for independent Viking dishwasher diagnosis.
Often after fixing an owner-safe condition and power-cycling once. If E:10 returns immediately, stop DIY and book independent service with Simply Iconic.
Two Viking units can share a display string yet map to different subsystems; verify against your serial family documentation.
Sources & references
Model, symptom, ZIP — we’ll confirm a visit
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Use the secure scheduler below to request your appointment.