Viking Dishwasher 2-2 Error Code
Viking controls may raise 2-2 on a dishwasher when sensors, interlocks, or electronics report an out-of-range condition. One careful reset is reasonable; recurring codes need independent diagnosis.
Content status: Reviewed — wording follows cited Viking service literature; confirm decode on your exact model.
Owner-facing Viking dishwasher fault note; exact text varies by control generation.
2-2 usually means a sensed fault on this Viking dishwasher. Confirm your manual before buying parts.
Model compatibility: Viking reuses codes across series and model years, so 2-2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Fill timeout — the dishwasher did not reach the expected water level in time. Verify supply valve open, fill line not kinked, adequate pressure, and unit level. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. Recurring faults after reset need an independent Viking technician via Simply Iconic.
Symptoms you may notice
- 2-2 flash pattern
- Little or no water entering tub
- Cycle stops during fill
Possible causes
- Closed or restricted water supply
- Kinked inlet hose
- Inlet valve or flow issue
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Confirm hot water supply fully open
- Check inlet hose for kinks
- Run kitchen faucet to verify pressure
- Reset the unit by pressing and holding the START button for four seconds, then try the cycle again.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
When 2-2 keeps returning, stop DIY inside panels and schedule Simply Iconic — bring photos of the display and rating label.
Likely related component
Water inlet / fill valve
Frequently asked questions
Fill timeout — the dishwasher did not reach the expected water level in time. Verify supply valve open, fill line not kinked, adequate pressure, and unit level. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. Recurring faults after reset need an independent Viking technician via Simply Iconic.
Many Viking codes drop after door, filter, or airflow issues are corrected. Returning 2-2 needs a tech.
Use your model’s use & care guide first; general pages only approximate 2-2.
Sources & references
Model, symptom, ZIP — we’ll confirm a visit
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Use the secure scheduler below to request your appointment.