Viking Dishwasher 5-2 Error Code
5-2 on a Viking dishwasher is a control diagnostic worth photographing before any reset. Start with the safe checks below, then confirm the wording in your model manual.
Content status: Reviewed — wording follows cited Viking service literature; confirm decode on your exact model.
Owner-facing Viking dishwasher fault note; exact text varies by control generation.
Independent Viking help for 5-2 (dishwasher): model tag + display photo speed the visit.
Model compatibility: Viking reuses codes across series and model years, so 5-2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Control memory fault — stored settings or calibration data failed a check. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. Persistent codes are a booking signal for Simply Iconic; approve any repair only after a written estimate.
Symptoms you may notice
- 5-2 flash pattern
- Settings may not save
- Erratic behavior after power event
Possible causes
- Corrupted control memory
- Failed control board
- Power surge
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Reset the unit by pressing and holding the START button for four seconds, then try the cycle again.
- Use surge protection
- Call service if code returns immediately
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
When to call a technician
Call Simply Iconic if 5-2 comes back, the appliance will not run safely, or you smell burning / see standing water near electrics.
Likely related component
Control memory / EEPROM
Frequently asked questions
Control memory fault — stored settings or calibration data failed a check. Reset the unit by pressing and holding the START button for four seconds, then try the cycle again. Persistent codes are a booking signal for Simply Iconic; approve any repair only after a written estimate.
Many Viking codes drop after door, filter, or airflow issues are corrected. Returning 5-2 needs a tech.
No — Viking control generations differ. Match 5-2 to your exact documentation.
Sources & references
Model, symptom, ZIP — we’ll confirm a visit
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Use the secure scheduler below to request your appointment.