Viking Oven PROBE ERROR
PROBE ERROR on a Viking oven means the meat probe circuit is open or shorted, according to the manufacturer error-handling guide.
Content status: Verified — wording follows a cited Viking use & care manual Error Handling entry.
Owner steps from Viking use & care manual Error Handling (PROBE ERROR).
PROBE ERROR — meat probe circuit open or shorted per Viking documentation.
Model compatibility: Viking reuses codes across series and model years, so PROBE ERROR may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Per the Viking use & care manual, PROBE ERROR indicates the meat probe is open or shorted. If the probe is not plugged in, plug it into the oven. Press OFF to clear the message. If the probe is connected and the error remains, contact an independent Viking technician.
Symptoms you may notice
- Display shows PROBE ERROR
- Roast/meat-probe modes may not start
- Error persists with probe inserted
Possible causes
- Meat probe not fully seated in the jack
- Open or shorted probe or cable
- Moisture or damage at the probe connector
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Ensure the meat probe is fully plugged into the oven jack
- Press OFF to exit and clear the error message
- If the probe is connected and PROBE ERROR remains, call independent service
Important safety warning. Do not open internal panels, access high-voltage wiring, or bypass any safety device. If you ever smell gas, stop immediately, do not operate any switches, leave the area and contact your gas provider and a qualified technician. If you see smoke, sparks, a burning smell, or water near electrical parts, switch the appliance off at the outlet if it is safe to do so and call a professional.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
- Do not adjust, disconnect or repair any gas connection or valve
When to call a technician
If PROBE ERROR continues with the probe properly inserted, contact an independent Viking technician as the manual directs.
Likely related component
Meat probe and probe jack
Frequently asked questions
If the probe was the issue, reseating or removing it and pressing OFF may clear the message. A damaged probe or jack needs service.
Use only the probe supplied with or specified for your model; incorrect probes can trigger probe faults.
Sources & references
Model, symptom, ZIP — we’ll confirm a visit
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Use the secure scheduler below to request your appointment.