Viking Oven F2 Error Code
On ERC5800-based Viking oven controls, F2 is documented as an oven over-temperature condition.
Content status: Reviewed — wording follows cited Viking service literature; confirm decode on your exact model.
F2 decode from Viking VEDO 273 service notebook (ERC5800).
F2 — oven over temperature (ERC5800 service literature). Decode varies by EOC generation.
Model compatibility: Viking reuses codes across series and model years, so F2 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
Viking VEDO service literature lists F2 as oven over temperature and directs checking sensor wiring, the sensor, and the temperature limiter. Viking uses multiple electronic oven control (EOC) generations; the same display can decode differently by model year. Record your model and serial numbers and confirm against your appliance documentation.
Symptoms you may notice
- F2 displayed
- Oven may shut down heating
- May follow runaway heat or a sensor fault
Possible causes
- RTD/temperature sensor fault or wiring issue (service literature)
- Temperature limiter tripped (service literature)
- On other EOC generations F2 may indicate sensor faults with different test values — confirm in your manual
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Turn off power at the breaker if the oven is overheating or F2 persists
- Do not use the oven until diagnosed if over-temperature is suspected
- Record model number for the technician
Important safety warning. Do not open internal panels, access high-voltage wiring, or bypass any safety device. If you ever smell gas, stop immediately, do not operate any switches, leave the area and contact your gas provider and a qualified technician. If you see smoke, sparks, a burning smell, or water near electrical parts, switch the appliance off at the outlet if it is safe to do so and call a professional.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
- Do not adjust, disconnect or repair any gas connection or valve
When to call a technician
If F2 returns after cooling and one power cycle, contact an independent Viking technician before further use — over-temperature conditions can be unsafe.
Likely related component
Oven temperature sensor (RTD), wiring, and limiter
Frequently asked questions
Related (temperature sensing) but different displays. Follow the message shown on your control and your manual.
Sources & references
Model, symptom, ZIP — we’ll confirm a visit
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Use the secure scheduler below to request your appointment.