Viking Oven NO PROBE Error Code
A Viking oven that logs NO PROBE is asking for confirmation against the use & care guide. Simply Iconic can diagnose independently if the code returns.
Content status: Reviewed — wording follows cited Viking service literature; confirm decode on your exact model.
Owner-facing decode for Viking controls — cross-check the use & care guide before any repair decision.
Viking oven code NO PROBE — safe owner checks first, then independent diagnosis if it returns.
Model compatibility: Viking reuses codes across series and model years, so NO PROBE may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
What this code means
If your Viking oven shows NO PROBE, treat it as a probe-dependent mode was selected but no probe is detected until sensors, keypad, or latch hardware are verified independently. Viking uses multiple control generations; confirm the decode in your model manual.
Symptoms you may notice
- NO PROBE displayed on the control
- Appliance may stop heating, lock out, or refuse to start
Possible causes
- Sensor, switch, or actuator fault (confirm in manual)
- Wiring or connector issue
- Control board detected an out-of-range condition
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
- Record model and serial numbers from the rating plate
- One breaker power cycle for two minutes if your manual allows
- Do not bypass safety interlocks or force doors
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
What not to attempt
- Do not open internal panels or access high-voltage components
- Do not bypass door locks, safety switches or interlocks
- Do not adjust, disconnect or repair any gas connection or valve
When to call a technician
For recurring NO PROBE, independent service is safer than guessing parts. Simply Iconic will diagnose on site and estimate before any repair.
Likely related component
Meat probe jack
Frequently asked questions
If your Viking oven shows NO PROBE, treat it as a probe-dependent mode was selected but no probe is detected until sensors, keypad, or latch hardware are verified independently. Viking uses multiple control generations; confirm the decode in your model manual.
Safe homeowner resets may clear NO PROBE temporarily; sealed, gas, and live-board work stay with a technician.
Two Viking units can share a display string yet map to different subsystems; verify against your serial family documentation.
Sources & references
Model, symptom, ZIP — we’ll confirm a visit
Share a few details and we’ll confirm an appointment. Prefer to talk? Call us and we’ll help right away.
Request your repair
Use the secure scheduler below to request your appointment.